On Fri, Aug 14, 2015 at 9:44 AM, Arthur Lewis via <tmg@rootsweb.com> wrote: > A few years back I recollect entering a code in the TMG toolbar which > enabled me to switch between TMG and SS without switching off TMG. This was > a significant time saver when editing SS. > > > > Can someone please tell me whether that device is still available and where > I can find it? I am using TMG v.9.05 and SS v. 5.3, Build 03. > > > > Arthur Lewis > Arthur, I have a toolbar button to close the project. This closes the project but not TMG. I then go to Second Site or even the Utility to do what I need. Then back to TMG where I have a second button to open my main project. This is a different but than the one on the left of the screen. This button is set to open a specific project so I don't have to enter a name. Patt -- Patt Ricketts www.jackandpatt.com

On 8/14/2015 8:20 PM, Patt Ricketts via wrote: > I have a toolbar button to close the project. This closes the project but > not TMG. > > I then go to Second Site or even the Utility to do what I need. > > Then back to TMG where I have a second button to open my main project. This > is a different but than the one on the left of the screen. This button is > set to open a specific project so I don't have to enter a name. > Patt, I do the same thing and find it very handy. However, be aware that after certain operations TMG fails to close all the files when you use the Close Project command, which causes an error when you try to run Second Site. When that happens you have to close TMG totally and run the Make Site command in Second Site again. Terry Reigel