Hi Terry, Thanks for the advice. I've been using this method since the close command was introduce in v8 and can't remember that happening. But thanks for the heads up. Patt On Fri, Aug 14, 2015 at 6:01 PM, Terry Reigel via <tmg@rootsweb.com> wrote: > On 8/14/2015 8:20 PM, Patt Ricketts via wrote: > > > I have a toolbar button to close the project. This closes the project but > > not TMG. > > > > I then go to Second Site or even the Utility to do what I need. > > > > Then back to TMG where I have a second button to open my main project. > This > > is a different but than the one on the left of the screen. This button is > > set to open a specific project so I don't have to enter a name. > > > > Patt, > > I do the same thing and find it very handy. However, be aware that after > certain operations TMG fails to close all the files when you use the Close > Project command, which causes an error when you try to run Second Site. > When that happens you have to close TMG totally and run the Make Site > command in Second Site again. > > Terry Reigel > > > The TMG archive is found here: > http://archiver.rootsweb.ancestry.com/th/index/TMG/ > Instructions on how to subscribe to TMG: > http://lists.rootsweb.ancestry.com/index/other/Software/TMG.html > ------------------------------- > To unsubscribe from the list, please send an email to > TMG-request@rootsweb.com with the word 'unsubscribe' without the quotes > in the subject and the body of the message > -- Patt Ricketts www.jackandpatt.com