It's the same problem discussed the other day with post 1930 transcriptions - a new version of BMDVerify is ready that fixes the issue, but there have been some technical issues that held up the release. Hope to have it available in the next two weeks. David > One of my experienced transcribers sent the following question to me, > which appears to be of general concern on the message boards at present. I have not seen any answers to it though: > > "I have just completed the first file of my 1933 2Q marriage assignment. > When using BMDVerify after transcription, and having made a correction, > every single time the file was reloaded BMDVerify brought up the message: > > "Is this a Death index or... > ...a Birth index with mother's surname or... > ...a Marriage index with wife's surname > YES NO > > As I had about 20 corrections to make, due mostly to supposed 5s in > transcription turning out to be 3s in verification, this became extremely > annoying. I had already told WinBMD it was one of these when I set up the > page header, and at the start of verification. Why does BMDVerify need to > know each time a correction is reloaded? And is there any way to turn it > off? I never had this message when doing 1924 marriages - what is so > different about 1933 marriages that this message keeps appearing, and the > columns don't line up during verification, which make it confusing and > more > difficult to see mistakes? I am using BMDVerify version 3.0.3/311006." > > Please can someone advise whether a new version of BMDVerify is being > made, > or if there is a solution to these problems? > > Lisa Dominey > ID4 Syndicate Coordinator > > > > >