At 06:26 PM 06/01/2000, Mike & Ginger Woodcock wrote: *************START OF ORIGINAL MESSAGE TEXT************* If you want to get cute, make the two lines: ReplyAttribution=At %1,you had the nerve to say: ReplyAllAttribution=At %1,Someone on This List said: Or whatever "cute" thing you want your replies to say. NOTE: I found out how to NOT have an Attribution at all!!!!! ReplyAttribution= ReplyAllAttribution= Just don't add ANYTHING after the equal sign! There will be NO Attribution in your "Reply" or "Reply to All". Hope this helps, SgtGeorge George, I have been very successful in adding the reply lines to my ini file.. I didn't find any to change, so just added them.. Now, I'd like to add the little seperator you use, ************END OF ORIGINAL MESSAGE TEXT************ can you tell me how to do that as well. :-) g **************END OF ORIGINAL MESSAGE TEXT************** Ginger, open EUDORA.INI in NotePad (or whatever is your favorite text viewer/editor. Under [Settings], put the following: ReplyStart=*************START OF ORIGINAL MESSAGE TEXT************* ReplyPrefix=> ReplyEnd=**************END OF ORIGINAL MESSAGE TEXT************** If you already have these three lines, just delete them and replace with the above. That should do it. SgtGeorge