Barry, You might check to see if for your default settings on your printer you have "fit to page" set. I have sometimes found that that can cause your problem to happen. When you go to print from Deedmapper, if you can get to the Properties before it actually prints (I forget whether you can or not) to turn that off, it may help. Turning it off inside an application should not change the default settings for other apps. -Nancy Upshaw -----Original Message----- From: dadster3@juno.com [mailto:dadster3@juno.com] Sent: Tuesday, August 19, 2003 8:30 PM To: DEED-MAPPER-USERS-L@rootsweb.com Subject: [DMU] Re: DEED-MAPPER-USERS-D Digest V03 #47 Mr. Wilson, Thanks for the reply regarding the problem with DeedMapper pagination. I've had this printer for several years and have never had a problem like this. It prints everything from e-mail to a DOS version of Quicken flawlessly. There is nothing to adjust in DeedMapper, as far as I know, but I do think it is a software issue, not hardware. You didn't say what you were printing as a test. I was trying to print the line editor deed descriptions, not the plots. Haven't gotten to that yet. Anyway, I've worked around it by send 5 or so deeds to the printer individually. They que up and print just fine. I find that I prefer printing in small batches anyway. If there is a paper jamb or something it's easier to stop the print job and less wasteful. Thanks, Barry Clark Fredericksburg, VA ______________________________