>1. Is it possible to view the preview of reports in a larger font? I find >it quite difficult to read them. I realise there is an enlargement button >on the bottom line but that is definitely not enough. It is so unusual not >to be able to zoom in. Three ZOOM options: 1. double page layout, 2. 70% which is basically the width of the paper but scrolling up and down required and 3. 100% which should normally allow you to see in full detail everything. Sorry, there is no other zoom. However, from your 2nd question I wonder if you have an older version of the program and may not have all these zooms. Current Ver is 2.32 (check Help Menu - About). >2. In the standard event editor, what is the objective of the nine (E Li, E >De, E Bo etc) 'things'? Garbage. Should not be in there. I think there was one version which was released with this junk in there. Have not heard of it for some time so am assuming you likely have an older version of the program. You can delete all these items. >3. In the window 'to select a source' there are the two panes. How/why is >the second pane used? Two panes: I assum you mean right and left panes? One says first part of record, the other end of record. Most sources are much longer than can be displayed in a single line as on the selection list displayed. And since many references may be nearly identical until the tail part of the source where a different page number (for example) may be shown, there was a need to be able to differentiate - thus the split list. Ira ---------------------------------------------------------- Ira J. Lund Cumberland Family Software, Clarksville, Tennessee, USA Genealogy Software for Beginners and Professionals E-mail: ira.lund@cf-software.com http://www.cf-software.com