At 01:26 AM 10/24/98 +0100, you wrote: >When I printed out a couple of pages of my Family tree today, instead of the >sources appearing at the end numbered as they have been before, they all >appeared with symbols instead. In the text, instead of the small foot note >type number, there was this symbol. I've consulted the manual, and can find >no reference to this. What have I done wrong ? How can I put it right again? The LUND font problem. The superscript lettering only works properly if the LUND fonts are installed properly. There are a set of 4 LUND fonts that were supposed to be installed when CFT-Win is installed. But for some reason, occaisionally, I get reports that the fonts didn't get installed. This is normally noticable by a few letters being cut off on the right hand side or on list reports where one column seems to run into the next. The solution: 1. If you are using Windows 3.1 go to the Control Panel and Fonts and install the 4 Lund fonts. They should have been copied into the c:\windows\system directory. 2. If you are using Window 95 then use Explorer to find the fonts. They should be in c:\windows\fonts. (Although some earlier versions of CFT-Win inadvertantly installed inot c:\windows\font - without the "s". If this is the case you may copy the four files to the proper location.) Anyway, if you double mouse-click on the fonts one at a time to view them, this should install them so that they will be recognized by CFT-Win - as well as other programs. Ira ---------------------------------------------------------- Ira J. Lund Cumberland Family Software, Clarksville, Tennessee, USA Genealogy Software for Beginners and Professionals E-mail: ira.lund@cf-software.com http://www.cf-software.com