I am running 2.27 32 bit and have no troubles like this. I have a few, well many infact that have spouses but no marriage event and when I entered the marriage for either spouse it was there for the other person OK. At 17:03 26/01/98 -0600, you wrote: >I will look into this. > >Ira > >At 10:28 AM 1/25/98 +1000, you wrote: >>Ira, >> >>I have just found a small bug with the add spouse routine in an unusual >>circumstance. This one has been lurking for a while but I only just >>realised the cause. >> >>Take the case of a family set, that is father, mother and child, but with a >>second family containing a child only. Selecting the second family gives a >>display showing the father and child, with the option of -Add-Spouse-. If a >>spouse is added through this option, it does not link into the FRN >>containing the child of the second family, but incorrectly replaces the >>spouse from the first family. >> >>Checking the original spouse from family number one shows the connection >>still exists. We therefore have two spouses with the same FRN. Any attempt >>to fix it loses the child connections, which have to be manually reinstated >>following a rebuild. >> >>Regards, >> >>Ian Fettes >>Brisbane, Queensland, Australia >>Reply to: fettesi@st.net.au >> >---------------------------------------------------------- > Ira J. Lund > Cumberland Family Software, Clarksville, Tennessee, USA > E-mail: ira.lund@cf-software.com > http://www.cf-software.com > Barry Gardiner <color><param>0000,0000,ffff</param>PO Box 427 <italic><underline>McLaren Vale South Australia 5171 </underline></italic></color> One of the finest wine grape growing areas in the world. email address's barryg@cobweb.com.au barryg@terra.net.au Motto: Don't take life seriously. You'll never get out of it alive.